![]() reason: invalid value - prop: firewall policy srcintf/dstintf cannot be used in system sdwan members interface(port1). Using the SD-WAN member interface to firewall policy instead of the SD-WAN interface:Įrror :131 - datasrc invalid. Technical Note: Policy Package gets imported incompletely into FortiManager Remove it from the firewall policy to allow it to be changed, then re-add it later.Ī similar bind error can also be encountered while importing configuration.įor details, refer to the following document: Note: Changing the interface binding is not possible if the address is used in a firewall policy. Solution: The bind-interface needs to be the same interface on both ends. Here, the SKIP flag triggers because these objects are not related to a specific firewall policy. However, the same address is bound as 'any' under FortiGate: In this example, the ' Test' address object binds with 'port6' under FortiManager. ![]() The most common cause is a conflict with the interface bind for address objects. ![]() If there are any mapping or binding conflicts, the 'copy' error occurs: The Copy process is where FortiManager copies the policies and policy-related objects from the ADOM DB to the device DB.The write summary step is where FortiManager prepares all the information that needs to be installed.Installation begins with two installation preparation steps.This article describes causes and solutions for the 'copy' error that occurs while performing an installation of the policy package.ĭuring installation of the policy package, FortiManager needs to copy the used shared objects from the ADOM Database to the Device Database.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |