Making the most out of the Micro Wireless takes a bit of getting used to the ClickTec Plus interface. The clock will take permanence of place in its blue bar in the middle. What’s interesting with the Micro Wireless is that you can customize its two display tiers. I find this useful for people who swap tires – say, on a cyclocross bike, where you might want to switch between 28 mm slicks for the road and 35 mm knobbies for mud. Later on, you can also set the circumference of the second (B) wheel size. Unfortunately it’s also done by multiple pushes of the gray Mode button, which I said before was about as fun to push as a pimple. Initial setup is done with the computer off its mount, then setting the speed units, time, clock format, and the primary of the two wheel sizes, marked by (A). You mount it on a rubber foot, put it on a fork blade within 60 cm of the computer’s underside, then secure with two zip ties. The Micro Wireless also shares the same speed sensor as the Commuter, Velo Wireless, and Velo Wireless+. Here it’s dubbed “ClickTec Plus” as there’s also an additional, rather tiny “SSE” button in the center. It also employs a variant of the ClickTec interface, where the entire lower face of the unit is pressed, activating buttons on the rear. As with other computers with ClickTec interface, pressing the face trips the gray button on the bottom.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |